Configuring OSPF virtual link settings

The OSPF interface parameters for this process are automatically set to their default values for virtual links. You can optionally adjust the following OSPF virtual link settings.

Prerequisites

You must be in the router vlink configuration context, as indicated by theswitch(config-router-vlink)#prompt.

Procedure

Set the time interval between OSPF hello packets for the OSPF virtual links using the following command. For command details, seehello-interval.
hello-interval
For example:
```
switch(config)#router ospf 1switch(config-ospf-1)#area 100 virtual-link 100.0.1.1switch(config-ospf-1)#hello-interval 30
```
Set the interval which a neighbor is declared dead if no hello packet is received on the OSPF virtual links. Use the following command. For command details, seedead-interval.

dead-interval
统计设置电源之间的时间失去了联系e advertisements for the OSPF virtual links using the following command. For command details, seeretransmit-interval.

retransmit-interval
Sets the transit delay in Link state transmission for the OSPF virtual links using the following command. For command details, seetransit-delay

transit-delay