show loop-protect

描述

Shows loop protection information for all interfaces or for a specific interface.

Command context

Operator (>) or Manager (#)

Parameters

Specifies the name of a logical interface on the switch. This can be one of the following:

• An Ethernet interface associated with a physical port. Format:member/slot/port.

• A LAG (link aggregation group). Specify the ID of LAG . For example:lag100.

[vsx-peer]

Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed. This parameter is available on switches that support VSX.

Authority

Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.

Examples

On the 6400 Switch Series, interface identification differs.

switch#show loop-protect传输时间间隔(秒):5端口Re-enable Timer (sec) : Disabled Loop Detected Trap : Enabled Interface 1/1/1 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up Interface 1/1/2 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up

switch#show loop-protect 1/1/3Status and Counters - Loop Protection Information Transmit Interval (sec) : 5 Port Re-enable Timer (sec) : 0 Loop Detected Trap : Disabled Interface 1 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up