anycast-rp source-directly-connected

anycast-rp source-directly-connected

[不]anycast-rp source-directly-connected

Description

Use this comand with an Anycast rendezvous point (RP) solution (for example, with MSDP) when the same multicast source is directly connected to two or more Anycast RP routers.

Usage

When configured this command allows only one RP who is the Designated Router (DR) in the segment to own the generation of the MSDP SA (Source Active) messages. If this command is not enabled, all Anycast RP routers where the source is directly connected would start advertising SA messages and form a loop. For example. when the source is directly connected to an Anycast RP VSX pair via VSX-LAG. Therefore this configuration is recommended when VSX pairs act as Anycast RPs. This command is optional when the source is directly connected to a single Anycast RP router or when the source is at least one hop away from the RP.

Examples

The following examples configure directly connected sources with Anycast RP, then remove the configuration.

switch(config)# router pim switch(config-pim)# anycast-rp source-directly-connected switch(config-pim)# switch(config-pim)# no anycast-rp source-directly-connected

Command History

Release

国防部ification

10.10

Command Introduced

Command Information

Platforms

Command context

Authority

8400

9300

config-if

config-if-vlan

config-lag-if

Users having admin privileges.