ap deploy-profile

blacklist /denylist

default-ap-group

enable

ip-range

ipv6-range

Description

This command applies the AP deployment policy to the default AP group, and/or to the list of AP MAC addresses included in the UAP blacklist /denylisttable, and/or to the specified IP address range. The AP deployment policy redirects the applicable APs to the Instant discovery process, ensuring that the APs run only incontroller表示“不”模式。

Parameter	Description
blacklist /denylist	Enables the blacklist /denylistpolicy. Applies the AP deployment policy to the APs whose MAC addresses are included in the UAP blacklist /denylisttable.
default-ap-group	应用the AP deployment policy to the default AP group.
enable	Enables the AP deploy profile. The policies configured are enforced only if this is enabled.
ip-range	应用the AP deployment policy to the specified IPv4 address range. You can define up to 128 IPv4 address ranges.
	Starting IPv4 address of the range.
< >结束	Ending IPv4 address of the range.
ipv6-range	应用the AP deployment policy to the specified IPv6 address range. You can define up to 128 IPv6 address ranges.
	Starting IPv6 address of the range.
< >结束	Ending IPv6 address of the range.
no	Removes the AP deploy profile configuration.

Example

The following set of commands enable the AP deployment policy :

(host) [mynode] (config) #ap deploy-profile

(host) [mynode] (ap deploy-profile) #enable

The following command applies the AP deployment policy to an IPv4 address range with a starting IP address of 1.1.1.1 and ending IP address of 1.1.1.10:

(host) [mynode] (ap deploy-profile) #ip-range <1.1.1.1> <1.1.1.10>

The following command enables the blacklist /denylistpolicy in the AP deploy profile:

(host) [mynode] (ap deploy-profile) #blacklist /denylist

The following command removes the AP deployment policy configuration:

(host) [mynode] (config) #no ap deploy-profile

Related Commands

Command	Description
show ap deploy-profile	The`show ap deploy-profile`command displays the complete list of IP address ranges to which the AP deployment policy is applied.
uap-blacklist / uap-denylist	This command adds AP MAC addresses to the UAP blacklist /denylistdatabase. When the blacklist /denylistpolicy is enabled in the AP deploy profile, it is applied to this blacklist /denylistdatabase entries.

Command History

Release	Modification
ArubaOS8.9.0.0	All instances of`blacklist`have been replaced with`denylist`.
ArubaOS8.2.0.0	Command introduced.

Command Information

Platforms	License	Command Mode
All platforms	Base operating system.	配置模式Mobility Conductor.