ap enet-link-profile {default |
克隆{默认| <酸ce>}
dot3az
dot3bz
duplex {auto | full | half}
no ...
poe
speed {10 | 100 | 1000 | 2500 | 5000 | auto}
Description
This command configures the duplex and speed of the Ethernet port on the AP. The configurable speed is dependent on the port type.
Parameter |
Description |
ap enet-link-profile |
Name of this instance of the profile. The name must be 1-63 characters long. |
clone |
Name of an existing Ethernet Link profile from which parameter values are copied. |
dot3az |
Enable support for the 803.az Energy Efficient Ethernet standard, which allows the APs to consume less power during periods of low data activity. If this feature is enabled for an AP group, any APs in the group that do not support 803.az will ignore this setting. disabled |
dot3bz |
Enable support for IEEE 802.3bz standard. Only330 Seriesaccess points are compliant with this standard. enabled |
duplex |
The duplex mode of the Ethernet interface, either full, half, or auto-negotiated. full, half, auto 汽车 |
no |
Negates any configured parameter. |
poe |
Enables PoE for APs that support PoE. |
speed |
The speed of the Ethernet interface, either 10 Mbps, 100 Mbps, 1000 Mbps (1 Gbps), or auto-negotiated. 10, 100, 1000, 2500, 5000, auto 汽车 |
Example
The following command configures the Ethernet link profile for full-duplex and 100 Mbps:
(host) [mynode] (config) #ap enet-link-profile enet
(host) [mynode] (AP Ethernet Link profile "enet") #duplex full
(host) [mynode] (AP Ethernet Link profile "enet") #speed 100
Command History
Release |
Modification |
ArubaOS8.0.0.0 |
Command introduced. |
Command Information
Platforms |
License |
Command Mode |
Available on all platforms |
Base operating system. |
配置模式Mobility Conductor. |
