no
override ap-name
Description
Convert an AP or AM into a spectrum monitor by adding it to the spectrum local-override list. There are two ways to change an AP that supports the spectrum monitor feature into a spectrum monitor. You can assign that AP to a 802.11a and 802.11g radio profile that is already set to spectrum mode, or you can temporarily change the AP into a spectrum monitor using a local spectrum override profile. When you use a local spectrum override profile to override the mode setting of an AP, that AP will begin to operate as a spectrum monitor, but will remain associated with its previous 802.11a and 802.11g radio profiles. If you change any parameter (other than the overridden mode parameter) in the spectrum monitor’s 802.11a or 802.11g radio profiles, the spectrum monitor will immediately update with the change. When you remove the local spectrum override, the spectrum monitor will revert back to its previous mode, and remain assigned to the same 802.11a and 802.11g radio profiles as before.
Parameter |
Description |
no |
Negates any previous AP spectrum local-override configuration |
override ap-name |
Specifies the name of an AP whose radio should be converted to a spectrum monitor radio. |
谱带 |
Specifies the spectrum band or portion of the band to be monitored by the spectrum monitor radio For 2GHz, channels 1–14 For 5 GHz, channels 36–64, 100–140 and 149–165 2 GHz |
Related Commands
Command |
Description |
This command shows a list of AP radios currently converted to spectrum monitors via the spectrum local-override list. |
Command History
Release |
Modification |
ArubaOS8.0.0.0 |
Command introduced. |
Command Information
Platforms |
许可证 |
Command Mode |
All platforms |
RF Protect license. |
配置模式Mobility Conductor. |
