configuration device

default-node

< mac地址>设备模型{A7005|A7008|A7010|A7024|A7030|A7205|A7210|A7220|A7240|A7240XM|A7280|MC-VA} []|move-to[][]

Description

This command maps a device to an existing node in the configuration hierarchy.

The node to which the device is mapped is specified by the node-path, which can be an absolute path from the root node or relative path from the current node. If the node-path is not specified, the device is mapped to the current node. A device-specific node is created to store the configuration for the device. The node is named using the specified MAC address of the device.

Use theshow configuration devicescommand to view the complete list of devices provisioned on yourMobility Conductor, and theshow configuration node-hierarchycommand to view the list of all nodes in the configuration hierarchy.

Parameter	Description
default-node	Specifies the node to which any device without explicit device-node mapping is attached. If a default node is not configured, unknown devices cannot connect toMobility Conductor.
< mac地址>	MAC address of a device that must be mapped to a node in the configuration hierarchy.
设备模型	Model number for the device: A7005 A7008 A7010 A7024 A7030 A7205 A7210 A7220 A7240 A7240XM A7280 MC-VA
	Full configuration path to which the device is mapped. If the path is not specified, the device is mapped to the current node.
move-to	Moves the device to the specified configuration path of the destination node.
	MAC address of the destination node in the configuration hierarchy.

Example

The following command specifies/mdas the default node:

(host) [mynode] (config) #configuration device default-node /md

Command History

Release	Modification
ArubaOS8.3.0.0	The`A7280`option was added under the`设备模型`parameter.
ArubaOS8.2.0.0	The following parameters were added: `move-to` `dest-path` `mac-address-2`
ArubaOS8.0.0.0	Command introduced.

Command Information

Platforms	License	Command Mode
All platforms	Base operating system.	配置模式Mobility Conductor.