service

service

dhcp

dhcpv6

network-storage

print-server

scp

no...

Description

This command enables the DHCP server on thecontroller. You can enable and configure DHCP, DHCPv6, network-storage, print server, or SCP in thecontrollerto provide the following clients:

DHCP: IP addresses to wireless clients if an external DHCP server is not available.

DHCPv6: IPv6 addresses to wireless clients if an external DHCPv6 server is not available.

Network-storage: To provide access to the storage devices attached to thecontrollerormanaged device.

Printer-server: To provide access to printers attached to thecontroller.

SCP: To provide SCP functionality on thecontrolleritself rather than on an external server.

Parameter	Description
dhcp	Enables the DHCP server
dhcpv6	Enables the DHCPv6 server
network-storage	Enables the NAS service
print-server	Enables the printer service
scp	Enables the scp server functionality on thecontrollerormanaged device
no...	Removes the specific configuration

Example

The following command enables the DHCP server in thecontrollerormanaged device:

The following command enables the DHCPv6 server in thecontrollerormanaged device:

The following command enables the NAS services in thecontrollerormanaged device:

The following command enables the printer services in thecontrollerormanaged device:

The following command enables the scp server functionality in thecontrollerormanaged device::

To disable the SCP server functionality on thecontroller, execute the following command:

Related Commands

Command	Description
show scp	Shows if the SCP server functionality is enabled or not.

Command History

Release	Modification
ArubaOS8.2.0.0	Thescpparameter was introduced.
ArubaOS8.0.0.0	Command introduced.

Command Information

Platforms	许可证	Command Mode
All platforms	Base operating system.	Configuration mode on thecontrollerormanaged device.