show ap monitor active-laser-beams

show ap monitor active-laser-beams {ap-name }|{bssid }|{ip-addr }|{ip6-addr }

Description

This command shows the active laser beam generators.

Parameter

Description

ap-name

Shows data for an AM with a specific name.

bssid

Shows data for an AM with a specific BSSID. The BSSID is usually the AM’s MAC address.

ip-addr

Shows data for an AM with a specific IPv4 address by entering its IPv4 address in dotted-decimal format.

ip6-addr < ip6-addr >

Shows data for an AM with a specific IPv6 address by entering its IPv6 address in dotted-decimal format.

band

Shows the radio band. Possible values are 2.4GHz, 5GHz, or 6GHz.

NOTE:The 6GHz value is applicable to Wi-Fi 6E APs only.

channel

Shows the AP channel.

Example

The following example lists the active laser beam sources for a specific BSSID:

(host)[mynode] (config) #show ap monitor active-laser-beams bssid f4:2e:7f:0b:a8:80

Active Laser Beam Sources ------------------------- bssid channel rssi ap name lms ip master /导体ip inactive time ----- ------- ---- ------- ------ --------- -------------

Command History

Release

Modification

ArubaOS8.9.0.0

The6GHzvalue was added toband parameter for Wi-Fi 6E APs.

ArubaOS8.0.0.0

Command introduced.

Command Information

Platforms

许可证

Command Mode

All platforms

英航se operating system.

Enable or Config mode onMobility Conductor.