show crypto-local ipsec [tag
Description
Displays the current IPsec map configuration on thecontroller. The commandshow crypto-local ipsecdisplays the current IPsec configuration on thecontroller.
Parameter |
Description |
tag |
Display a specific IPsec map. |
Examples
The commandshow crypto-local ipsec-mapshows the default map configuration along with any specific IPsec map configurations.
Crypto Map Template"ipv4mtu-standalone" 5 IKE Version: 2 IKEv2 Policy: 100 Security association lifetime seconds: 86400 Security association lifetime kilobytes: N/A PFS (Y/N): N Transform sets={ default-transform } Peer gateway: 10.15.141.113 Monitor IP: 0.0.0.0 Interface: VLAN 143 Source network: 3.4.5.6/255.255.255.255 Destination network: 1.2.3.4/255.255.255.255 Pre-Connect (Y/N): Y Client NAT mode (Y/N): N Tunnel Trusted (Y/N): Y Forced NAT-T (Y/N): Y Uplink Failover (Y/N): N Force-Tunnel-Mode (Y/N): N Uplink LoadBalance (Y/N): N IP Compression (Y/N): N DPD counters req_initd:95 req_resent:2 reply_recvd:95 peer_dead:0 DPD counters req_recvd:80 reply_sent:80 XCHG counters peer dead:0 CFG_SET Initiate Sent/Retry-NoACK/Retry-NoVLAN/Ack-Recvd= 0/0/0/0 CFG_SET Responder Recvd/Ack-sent= 0/0 Tunnel status IPSEC: UP IKE: UP IPSEC MTU: 9216
PPK ID: 1234
Related Commands
Command |
Description |
Use this command to configure IPsec mapping for site-to-site VPN. |
Command History
Release |
Modification |
ArubaOS8.10.0.0 |
Displays PPK ID in the IPsec map configurations on acontroller. |
ArubaOS8.0.0.0 |
Command introduced. |
Command Information
Platforms |
许可证 |
Command Mode |
All platforms |
Base operating system. |
Enable or Config mode onMobility Conductor. |
