show port status [
Description
Displays the status of all ports on thecontroller.
Parameter |
Description |
Physical port in格式。 |
Example
The output of this command shows the status of all ports in thecontroller.
(host)[mynode]# show port status
Port Status
-----------
Slot-Port PortType AdminState OperState PoE Trusted SpanningTree PortMode Speed Duplex PortError
--------- -------- ---------- --------- --- ------- ------------ -------- ----- ------ ---------
0/0/0 GE Enabled Up N/A Yes Disabled Trunk 10 Gbps Full -
0/0/1 GE Disabled Down N/A Yes Disabled Access Auto Auto -
The output of this command includes the following parameters:
Parameter |
Description |
Slot-Port |
Physical port in格式。 |
PortType |
Displays the type of physical port.
|
AdminState |
Indicates if the physical port is enabled or disabled. |
OperState |
Indicates if the current status of the physical port is up or down. |
坡 |
Indicates if the physical port is Power over Ethernet (PoE) enabled. |
Trusted |
Indicates if the physical port is trusted. |
SpanningTree |
Indicates the state of spanning tree. |
PortMode |
Indicates the port mode of the physical port. |
Speed |
Indicates the port speed. |
Duplex |
Indicates the direction of traffic. |
PortError |
Indicates is there is an error in the physical port. |
Command History
Release |
Modification |
ArubaOS8.0.0.0 |
Command introduced. |
Command Information
Platforms |
许可证 |
Command Mode |
All platforms |
Base operating system. |
Config or Enable mode onMobility Conductor. |
