wms ap
wms ap
Description
This command allows you to classify an AP into one of the several categories.
If AP learning is enabled (with theids-wms-general-profile learn-ap
命令),non-ArubaAPs connected on the same wired network asArubaAPs are classified as valid APs. If AP learning is disabled, a non-ArubaAP is classified as an unsecure or suspect-unsecure AP.
Parameter |
Description |
BSSID of the AP. |
|
mode |
Classify the AP into one of the following categories. |
suspected-rogue |
A suspected rogue AP that is plugged into the wired side of the network but may not be an unauthorized device. Automatic shutdown of rogue APs does not apply to these devices. |
The confidence level setting for the suspected rogue AP. |
|
interfering |
An AP seen in the RF environment but is not connected to the wired network. |
manually-contained |
Manually enables denial of service from this AP |
neighbor |
An neighboring AP whose BSSID is known. |
rogue |
A rogue AP that is unauthorized and is plugged into the wired side of the network. You can configure automatic shutdown of rogue APs in the IDS unauthorized device detection profile. |
valid |
An AP that is part of the enterprise providing WLAN service. |
<增加> |
Create an entry, if not already present, for the AP classification mode. |
Resend the mode even if there is no change. |
|
源> < |
The source of the manual reclassification. Select one of the following: admin: Manual reclassification is done from the CLI. amp: Manual reclassification is done fromAirWave. restapi: Manual reclassification is done from the REST API. webui: Manual reclassification is done from the WebUI. admin |
Examples
The following example classifies an interfering AP:
(host) [mynode] #wms ap 01:00:00:00:00:00 mode interfering
The following example assigns manual reclassification source to the monitored AP:
(host) [mynode] #wms ap 80:8d:b7:80:da:74 mode valid source admin
Command History
Release |
Modification |
ArubaOS8.8.0.0 |
The |
ArubaOS8.0.0.0 |
Command introduced. |
Command Information
Platforms |
License |
Command Mode |
All platforms |
Base operating system |
Enable or Config mode onMobility Conductor. |