What's New inAirWave8.2.12.0

This section lists the commands introduced, modified, or deprecated inAirWave8.2.12.0.

New Commands inAirWave8.2.12.0

The following commands were introduced inAirWave8.2.12.0:

Command	Description
8-2 Enter Commands > disable_allowlist	This enter command is introduced as part of terminology change. Across products Whitelist term is changed to Allowlist . So the earlier commanddisable_whitelistis replaced withdisable_allowlist.
8-2 Enter Commands > intfinorder	This enter command enables the VisualRF feature to send notifications as a rabbitmq message on any change happening in floor plans. You can use the same enter command to disable the feature. InAirWave8.2.12.0, the interfaces would be named like eno1,eno2../ ens2f0 depending on on-board/PCIe slot where the NIC is plugged-in. These interface names would be translated to ethX names during every boot-up using newly introduced start up module. Fresh install toAirWave8.2.12.0 will automatically update the GRUB and switch to this new naming convention, however upgrades toAirWave8.2.12.0 or later from previous releases need this enter command to be executed atleast once (on HPE proliant physical servers) for GRUB to be modified and effected.
3-6-4 CLT On Demand	这CLIcommand allows you to start the data upload to AWS S3 immediately with bootstrap data.
3-6-5组活体供体上传锚点	这CLIcommand in Configuration menu allows you to change the CLT upload time. This command changes the daily upload from 00:00 hours to the specified upload time in the command.
3-6-6 CLT Data Integrity Test	这CLIcommand in Configuration menu allows you to check the integrity of data that will be uploaded to AWS.
3-6-7 Check CLT connectivity	这CLIcommand in Configuration menu allows you to check the connectivity to external AWS related sites before configuring CLT.
3-6-7-1 Test GW connectivity	这CLIcommand in Configuration menu allows you to check if Nook GW is connecting properly. Main purpose is to identify firewall issues that could impact CLT.
3-6-7-2 Test AWS S3 connectivity	这CLIcommand in Configuration menu allows you to check if AWS S3 is connecting properly. Main purpose is to identify connectivity issues that could impact CLT.
3-6-7-3 Test AWS STS connectivity	这CLIcommand in Configuration menu allows you to check if STS is connecting properly. Main purpose is to identify connectivity issues that could impact CLT.