Member number

To add a device to a VSF stack, the device must be renumbered to the corresponding member ID. The user can specify the member number of the switch. The default member number is 1.

  • For the 6200F device, the default number can be changed to any value from 2 through 8. (The device supports up to 8 members.)

  • For 6300 devices, the default number can be changed to any value from 2 through 10. (The device supports up to 10 members.)

Refer to粘胶短纤renumber-toandMisconfiguration recoveryfor information about renumbering a member.

NOTE:

改变成员数量causes the switch to reboot and all configuration on the switch is removed.

A switch with a member number other than 1 cannot boot completely unless it has reachability to a VSF master switch via VSF link. If a renumbered member is unable to communicate with the master switch and is waiting in booting state, the user can:

  • Go to a recovery console with actrl + csequence and collect the diagnostic information, or

  • Reset the VSF configuration.