show ap spectrum debug status

显示ap谱调试状态{ap-name < ap-name > |ip-addr | ip6-addr } [freq-band {2.4ghz | 5ghz | 6ghz}]

Description

This command shows detailed status and statistics for a spectrum monitor or hybrid AP. Use the command under the guidance of a nArubatechnical support representative to troubleshoot spectrum analysis errors.

Parameter	Description
ap-name	Name of the spectrum device for which you want to view status information.
ip-addr	IP address of the spectrum device for which you want to view status information.
ip6-addr	IPv6 address of the spectrum device for which you want to view status information.
freq-band {2.4ghz \| 5ghz} ( For versions prior toArubaOS8.9.0.0)	View information for a specific radio type, either 2.4 GHz or 5 GHz.
freq-band {2.4ghz \| 5ghz \| 6ghz} ( ForArubaOS8.9.0.0or later versions)	View information for a specific radio type, either 2.4 GHz, 5 GHz, or 6 GHz. NOTE:The 6ghz sub-parameter is applicable to Wi-Fi 6E APs only.

Example

The following is an example for executing this command:

(host) [mynode] #show ap spectrum debug status ap-name ap-205 freq-band 5ghz

Related Commands

Command	Description
ap spectrum local-override	Converts an AP or AM into a spectrum monitor by adding it to the spectrum local-override list.
rf dot11a-radio-profile mode spectrum-mode	Sets an 802.11a radio so that the device operates as a spectrum monitor and can send spectrum analysis data to a desktop or laptop client.
rf dot11g-radio-profile mode spectrum-mode	Set an 802.11g radio so that the device operates as a spectrum monitor and can send spectrum analysis data to a desktop or laptop client.

Command History

Release	Modification
ArubaOS8.9.0.0	The`6ghz`sub-parameter was introduced for`freq-band`parameter. (ForArubaOS8.9.0.0 or later versions)
ArubaOS8.0.0.0	Command introduced.

Command Information

Platforms	License	Command Mode
All platforms.	Base operating system.	Enable or Config mode on themanaged deviceorcontrollerwhere the AP terminates.