配置uring Group Settings for Wireless
- 配置ure AP Group Settings
- 配置网关组设置

配置uring Group Settings for Wireless

Aruba Central uses a two-level hierarchy for configuration tasks. A device’s final configuration is a result of configuration that is applied at the group level, along with configuration that is applied at a device level. Parameters added at the device level override the configuration performed at the group level. Aruba recommends performing the bulk of the configuration at the group level and only using device-level configurations when specific overrides are needed.

配置ure AP Group Settings

Use this procedure to configure group settings for APs. An AP Group guarantees common settings are consistently applied across a group of APs in the network.

Note:The best practice is to use the fewest groups necessary to provide logical organization for the network and consistent configuration between devices. Configuration cannot be shared between groups.

第1步Navigate to中央并使用管理员登录credentials.

第2步On the Central Account Home page, launch the网络运营应用程序。

第3步在过滤器下拉列表中，选择AOS10Group name. In this example, selectUI-WIRELESS.

Step 4From the left menu, selectDevices.

Step 5在“接入点”页面的右上角，选择配置，然后选择Show Advanced.

Step 6On the Access Points page, select theSystemtab.

Step 7On the System tab, implement the following settings, and then selectSave Settings.

Set Country code for group:US - United States
Timezone:Pacific-Time UTC-08
首选乐队：全部
NTP Server:10.2.120.99, 10.2.120.98

Caution:网络内的时间同步不正确可能导致身份验证错误。

Note:全部APs in the group must have the same country code, so you must create a group for each country code in the network. The country code must be set before a configuration is pushed to an AP.
An NTP server defined in the Group configuration takes precedence over NTP configured with DHCP.

Step 8On the Access Points page, select theServices标签，展开AppRF部分，实现以下设置，然后选择Save Settings.

深包检测：全部
应用监控：向右滑动
Airslice政策：向右滑动

Note:Aruba AppRF is an application aware firewall running within the APs providing application visibility and control capabilities. APs with Deep Packet Inspection (DPI) enabled can inspect the data payload within packets to identify applications in use. DPI also allows the creation of rules to determine client access to applications and websites, as well as traffic shaping policies. For a complete overview of Aruba AppRF, refer to the appropriate version ArubaOS User Guide.
Occasionally Central features are released under Select Availability. If a documented feature does not appear in the Central application, contact an Aruba SE or Aruba TAC to request feature access.

配置网关组设置

Use this procedure to configure group settings for gateways. The best practice is to put APs and gateways in the same group in order to simplify navigation between the two settings tabs when deploying the network.

第1步Navigate to中央并使用管理员登录credentials.

第2步On the Aruba Central Account Home page, launch the网络运营应用程序。

第3步在过滤器下拉列表中，选择AOS10Groupname.

Step 4From the left menu, selectDevices, and then at the top, select门户s.

Step 5在网关页面的右上角，选择配置.

Step 6If this is the first time using the AOS10 group to configure a gateway, the Set Group Type pop-up will appear. Select门户and clickSave Settings.