BGP Template

使用BGP模板将BGP配置应用于SD-WAN结构中的所有设备。

1. 点击the edit icon next to the segment for which you want to modify the configuration.

2. Configure the following elements as needed:

   场地	Description
   作为路径传播	选择是的to enable this appliance to send the full AS path associated with a prefix to other routers and appliances, avoiding routing loops. This will provide the learned path from an external prepend between a remote BGP site to local BGP peers.
   Graceful Restart	选择是的to enable receiver-side graceful restart capability. EdgeConnect retains routes learned from the peer and continues to use it for forwarding (if possible) if/when a BGP peer goes down. Retained routes are considered stale routes. They will be deleted and replaced when new routes are received.
   最大重新启动时间	If Graceful Restart is enabled, specifies the maximum time in seconds to wait for a capable peer to come back after a restart or peer session failure.
   过时的路径时间	如果启用了优雅的重新启动，请在删除与同伴相关的陈旧路由之前，指定对等重新启动后的最大时间。
   下一步自我	Advertised route connected to a CE router that an EdgeConnect appliance learns from a PE router.
   Keep Alive Timer	这是秒内的间隔，在保持对等的信号之间。
   保持计时器	当丢失对等方的可用性时，此值指定在删除会话之前需要等待多长时间。
   启用MD5密码	如果应用了，请添加一个密码以与对等式身份验证TCP会话。
   密码确认密码	If the MD5 password is enabled, use these fields to specify the password.

3. 点击Update。

---